50kg load cell

Yes, a single-point 50kg cell is actually sized for that. You'll typically mount it under a platform roughly 300×300mm or smaller. Just make sure the load stays centered—off-center loading can introduce errors even if you're within the rated capacity.

IP65 keeps dust out and handles light water jets, so it's fine for washdown areas in food processing. IP67 means the cell can be submerged up to 1 meter for 30 minutes. If you're installing it in a pit that might flood or an outdoor monitoring station, spring for IP67 or IP68.

In most cases, yes. Kingmach machines the elastomer from bar stock, so thread size and center distance can be adjusted without retooling the entire cell. Lead time extends slightly, but you won't end up welding adapter plates that compromise the load path.

That depends on your PLC's analog input. If it has a dedicated strain gauge input (sensing mV/V), you can wire it directly. More commonly, you'll need a strain gauge amplifier or transmitter that converts to 0-10V or 4-20mA. Kingmach can supply the cell with a matched amplifier already trimmed to your span.

Creep and zero drift are part of sensor physics—our design minimizes them, but they're not zero. We include a factory calibration sheet, and we recommend a yearly check with a known deadweight. For critical loops, an in-line calibration verification adapter can be added to the mounting assembly so you can hang a reference weight without disconnecting the load cell.